Battery Li-Ion Plus 14,4 V, 2,5Ah REMS 571545 R14

REMS 571545 R14 supplies 14.4V power to cordless pipe pressing equipment. The 2.5Ah capacity supports extended work cycles on site. Li-Ion Plus chemistry ensures rapid recharge and consistent discharge curves. This battery integrates with Mini, Power Press, and Akku-Press platforms. Lightweight construction reduces operator fatigue during overhead or confined-space tasks.

Technical construction of the REMS 571545 R14 battery

The cell pack uses lithium-ion chemistry rated at 14.4 volts nominal. Capacity reaches 2.5 ampere-hours under standard discharge conditions. Housing material resists light impact and dust ingress. Contact terminals match REMS tool interfaces for secure electrical connection. Internal protection circuits guard against over-discharge and thermal runaway.

• Voltage: 14.4 V
• Capacity: 2.5 Ah
• Chemistry: Li-Ion Plus
• Charge time: approximately 60 minutes with compatible charger
• Compatible tools: Mini, Power Press, Akku-Press

The battery slides into the tool handle until the latch clicks. Charge-level indicators on some tool models read cell voltage directly. Replacement takes seconds without tools or fasteners. Balanced cell design maintains even discharge across the pack lifespan.

Compatibility and system integration

This pack works across REMS 14.4V cordless pressing platforms. Mini series tools accept it for copper and stainless-steel tube work. Power Press models use the same interface for larger-diameter fittings. Akku-Press units share the battery mount and electrical protocol. Cross-platform use simplifies inventory for multi-tool crews.

• Mini series: all 14.4V variants
• Power Press: 14.4V cordless models
• Akku-Press: 14.4V pressing tools
• Charger compatibility: REMS 14.4V Li-Ion chargers

Interchangeable design lets operators rotate batteries between tools during the shift. One charger serves multiple packs when workflow demands continuous uptime. The standardized footprint eliminates adapter plates or custom brackets.

Charging and cycle performance

A compatible REMS charger restores full capacity in roughly 60 minutes. Fast-charge circuitry tapers current near completion to protect cell health. The pack tolerates partial recharge cycles without capacity loss. Li-Ion Plus formulation resists self-discharge during storage periods.

• Full charge duration: ~60 minutes
• Partial-charge capability: yes, no memory effect
• Self-discharge rate: low (Li-Ion Plus)
• Cycle life: manufacturer-rated for professional use

Operators can top up the battery during lunch breaks or between job sites. Charge status typically shows via LED indicators on the charger base. Consistent voltage output maintains pressing force throughout the discharge curve.

Common applications for the 14.4V Li-Ion battery

Installers use this battery for pressing copper and stainless-steel pipe in HVAC, plumbing, and gas distribution systems. It powers tools on scaffolding, in mechanical rooms, and at remote outdoor sites. Maintenance crews carry spare packs for emergency repairs where mains power is unavailable. The 2.5Ah rating suits medium-duty cycles with periodic tool rest intervals.

Storage and handling guidelines

Store the battery at partial charge when not in use for extended periods. Avoid exposure to temperatures below freezing or above 50 °C. Keep terminals clean and free from metal debris that could cause short circuits. Inspect the housing for cracks before each shift. Replace the pack if charge time increases significantly or runtime drops sharply.

• Storage charge level: 30–50 percent recommended
• Temperature range: 0–50 °C operational, 5–25 °C storage
• Terminal maintenance: wipe contacts with dry cloth
• Replacement indicators: reduced runtime, prolonged charge cycles

Rotating two or three batteries extends tool availability across the workday. Label packs with purchase dates to track cycle age. Dispose of end-of-life cells through authorized recycling channels per local regulations.