One-hand cable cutter FELCO C7 Ø7 mm, 190 mm

The one-hand cable cutter FELCO C7 is designed to cut steel, copper, and aluminium cables up to Ø7 mm. It can cut single galvanised wire up to Ø4 mm and hardened springs up to Ø2.7 mm. The cutting head features a triangular slot, with angled blade edges that hold the strands securely as the jaws close, resulting in a clean cut end without flattening or fraying.

The blades and centre bolt are made from hardened HSS steel. The blade section is manufactured separately from the handle and attached with four rivets. The bolt connecting the two halves remains tight throughout the tool’s service life. Handles are pressed from 2 mm steel in a U profile and covered with a soft, non-slip plastic coating. A thumb catch on the head locks the jaws closed, allowing the cutter to be opened and locked with one hand. The tool is manufactured in Switzerland.

One-hand cable cutter FELCO C7 construction and cutting system

Blades and cutting geometry

The cutting slot is triangular, formed by two bevelled edges. This geometry traps the cable and prevents the strands from slipping out during cutting. HSS steel ensures the edge remains sharp under repeated use and resists wear. The centre pivot bolt is made from forged, hardened steel, supporting the force transmitted from the long handles into the compact cutting area.

• Triangular cutting slot grips the cable during cutting
• Blades made from HSS high speed steel, wear resistant
• Hardened centre bolt and pivot for optimal load transfer
• Blade section is separate from the handle, fixed by four rivets
• Produces a clean cut end without crushing or fraying

Because the blade unit is riveted rather than cast as a single piece, the hard steel is concentrated where the cutting occurs. Handle material is chosen for bending strength. Worn head parts can be replaced using FELCO spare parts, including blade with screw, lock nut, and bushing, all available as separate items.

Handles, spring and one-hand operation

The handles are pressed steel sheet in a U section, 2 mm thick, providing resistance to bending during tough cuts. The outer plastic sleeve ensures a secure grip, even with wet or oily hands. A coil spring, similar to those used in FELCO pruning shears, keeps the jaws open between cuts. The thumb catch allows the tool to be closed and locked in a single movement.

• Pressed steel U-section handles, 2 mm thick
• Soft ABS plastic sleeve with non-slip grip
• Coil spring returns jaws to open position
• Thumb catch for one-hand locking
• Total length 190 mm, weight 270 g

The 190 mm length allows the cutter to fit in a tool pouch or belt holster. Weighing 270 g, it is easy to use overhead or on ladders. The locking mechanism matches other FELCO shears, so users familiar with the brand require no additional training. The spring is a replaceable wear part, consistent with FELCO’s maintenance philosophy.

Common applications

This tool is suitable for fencing, rigging, electrical, and maintenance work. Typical uses include trimming multi-strand steel cable, cutting barbed and galvanised fence wire, shortening tension springs, and cutting light chain. Cutting capacity depends on material hardness, so the stated diameters apply to the corresponding material type. Always match the workpiece to the rated diameter to maintain blade condition.

Catalog notes

The catalog highlights four features.

• A triangular cutting system gives clean cuts without squashing.
• Blades and centre bolt are made from high-quality hardened steel.
• A thumb catch allows one-hand operation.
• Pressed steel handles have a non-slip coating.

Capacity ratings are cable Ø7 mm, single wire Ø4 mm, and spring Ø2.7 mm. Related service parts include three item codes.

• C7-4 is a related service part.
• C7-5 is a related service part.
• C7-10 is a related service part.