The REMS RAS Cu pipe cutter, article 113260 R, cuts pipes from 3 to 28 mm in diameter, i.e. 1/8 to 1 1/8 inch. The cutter is used for copper pipes. The cutting wheel runs around the pipe, tightening a little more with each turn until the pipe is severed. Genuine REMS item.
The REMS RAS Cu pipe cutter, article 113260 R, is a hand-held pipe cutter from REMS. It cuts pipes with an outside diameter from 3 to 28 mm, that is 1/8 to 1 1/8 inch. The manufacturer states the cutter is for copper pipes. The cutter wheel bears against the pipe wall, the tool is rotated around the pipe and tightened a little further with each turn. This cutting method produces an even, round cut edge without denting the pipe.

The guide rollers keep the pipe centred throughout the cutting travel. The spindle in the handle adjusts the opening width to the pipe size. The cutter wheel can be replaced when worn. The tool suits air conditioning installers, plumbers and electro-mechanical technicians. Supplied in a hanging blister pack according to the manufacturer's packaging specification.
Clamp lightly, turn one full revolution, then tighten a little more each time rather than tightening hard in one go. Keep the cutter at a right angle to the pipe so the cut does not run askew. Wipe chips and metal dust off the cutter wheel after use. Apply a little oil to the spindle and the rollers, and store the tool in a dry place.

















| SKU Code | Price (EUR) | Stock | |
|---|---|---|---|
| Loading variants... | |||
